Use this guide to choose a suitable mounting position, secure the camera base, route the power cable, and check the viewing angle after installation.

Choose the Mounting Position

- For entrances, position the camera so faces are visible rather than only the tops of heads.
- For a room overview, favor wide coverage with fewer blind spots.
- For baby or pet monitoring, leave enough space for pan/tilt movement.
- Avoid strong light shining directly into the lens.
- Avoid mounting behind glass when using night vision because reflections can affect the image.
- Avoid very tight corners that restrict useful pan/tilt coverage.
- Choose a position that is not easy to reach or accidentally knock.
Prepare the Mount

Wood may only require suitable screws or pilot holes. Concrete, brick, or weaker wall material may require appropriate anchors and a matching drill bit.
Wall or Ceiling?

Install the Camera
[step] 1. Remove or separate the mounting base from the camera. 2. Place the drill template at the chosen position and mark the mounting holes. 3. Check the cable direction before drilling, especially for a ceiling installation. 4. Drill suitable holes for the mounting surface. 5. Insert anchors when the surface requires them. 6. Fasten the mounting base firmly without overtightening the screws. 7. Attach and lock the camera onto the mounting base. 8. Connect power and route the cable along a safe, tidy path. [/step] [tip] Leave a little cable slack near the camera instead of pulling the cable tight. This reduces strain on the connection if the cable is moved. [/tip]Adjust the View
- Open Live View and use the pan/tilt controls to set the main viewing direction.
- Keep the most important area near the center of the frame.
- For entrances, check that faces appear at a useful height in the image.
- If night footage shows bright haze or reflections, move the camera away from glass, mirrors, glossy surfaces, or strong nearby lights.
- A slight downward angle may help reduce reflections from nearby surfaces.
Ceiling Mount Orientation
A ceiling-mounted camera may show an upside-down image until the display orientation is adjusted.
[step] 1. Open the EZVIZ app and select the camera. 2. Open the camera settings. 3. Look for the image flip, rotation, or display-orientation setting. 4. Adjust the setting until Live View is correctly oriented. [/step] [note] Setting names can vary slightly depending on the app version. [/note]Check the Installation
[checklist] * Live View loads normally at the mounted position * Important areas are visible in the frame * Motion or notification behavior is checked if those features are in use * Microphone and two-way audio are checked if needed * Mounting base does not wobble * Camera is securely attached to the base * Power cable is not stretched or exposed to accidental pulling [/checklist]Long-Term Care
- Choose a position that still allows reasonable access to the camera, reset area, and MicroSD card area when needed.
- Clean the lens gently with a microfiber cloth. If necessary, lightly dampen the cloth with clean water.
- Avoid household cleaners that may leave residue on the lens.
- Avoid mounting directly above stoves, very steamy areas, or equipment that stays unusually hot.